Current probe

In electrical and electronic engineering, a current clamp or current probe is an electrical device with jaws which open to allow clamping around an electrical . From current probes for oscilloscopes to current sensors for power meters, Hioki current probes and sensors deliver broadban high-accuracy performance. Enhance your measurements for . Current probes allow you to measure DC or AC current. Innovative DC to 5MHz positional current probe capable of measuring currents in PCB tracks, component legs etc.

Frequency bandwidth: DC to 1MHz. Maximum continuous input range: Arms. Contact one of our experts today.

Flexible current probes are designed to take measurements where standard clamp-ons cannot: in tight breaker panels, around large buss bars, around cable. Active current probe with voltage output for measuring of AC and DC currents with auto zero adjustment and auto power off function. This high value current probe is specifically designed to support measurements with Tektronix . Dranetz recommends only Dranetz-brand probes be used with Dranetz power quality.

The DCflex is an easy to use, low cost, thin and clip-around DC current probe.

Low-noise, high quality measurement signal for side channel acquisition on embedded devices. Olympus eddy current probes consist of the acquired brands of Nortec and NDT Engineering. We offer more than 10standard and custom designed eddy . Wall current probe : a non-invasive in situ plasma diagnostic for space and time resolved . A current probe is used as a “pick-up” device for measuring RF current in single conductors or . L, LT, LTC, LTM, Linear Technology . Measurement – Design Note 101. The ACP Series is an AC current probe using the Rogowski principle. The flexible and lightweight measuring head enables quick and easy installation in hard to . The servicing instructions are for use by qualified personnel only.

To avoid personal injury, do not. Vmd is the voltage developed . A characteristic of this type of current probe is that it has response. Thus the calibration curve of the current probe is valid only when the probe is terminated in the same impedance as was used in the course of its calibration . Most applications allow the current probe to be connected into the DMM, usually in the lowest voltage position. If this sounds complicated and does not seem to . These 000A probes come in 12″, 24″, 36″, and 48″ lengths that allow you to easily .

A large-dynamic-range current probe for microsecond pulsed vacuum breakdown research is fabricated. The basic principle of this probe is to turn the current . Most of the time, EMC engineers are looking for unwanted current flow, so the H- field probes are more useful. Many of the commercial H-field probes are .